m35 - Kodak M35 (Refurbished)

Processing Cycle:	2-1/2 minutes
Dimensions:	Length: Length w/feed tray:	29.7in 42.4in
	Width:	26.5in
	Height:	20.5in
	Weight:	Approximately 253 lbs. with processing tanks filled with solution; 200 lbs. empty
Electrical Requirements:	115 volt; 20 amp, single circuit
Water Requirements:	Requires cold water only.
Drain Requirements:	Floor drain with a capacity of 10.5 gpm to drain all tanks simultaneously All tanks can be emptied individually. Do not use brass or copper
Dryer Exhaust:	Approximately 75 cubic ft/minute

DESCRIPTION:
The refurbished M35A film processor requires cold water only. A cold-water kit is added to the plumbing configuration to accommodate cold water operation. These units have two electronically-controlled temperature sensing systems-dryer and developer. The dryer system is maintained through a new dryer-sensing 800 temperature control board and a new adjustable dryer potentiometer. The dryer heaters are protected with a manual reset overtemp safety thermostat. The developer temperature control system is maintained through the use of a new thermistor and a new developer heater assembly. This system is also protected by an overtemp safety thermostat, where the sensing circuits on the 100 PCB board monitor and control all activities of the two systems. Other configurations available upon request.

Price:

$7,995.00

Required fields are marked with a star (*). Click the 'Add To Cart' or 'Add To Wish List' button at the bottom of this form to proceed.

Account Menu

Recently Visited Pages

Popular Pages

PO Box 107 Montgomery, West Virginia 25136 United States

Telephone: (888)mtn-xray (888)686-9729 Fax: (304)442-2004